Create an MSDP peer

Perform the following procedure to establish a peer relationship between the local MSDP enabled router and a peer in another domain.

Important

Do not enable more than 20 active peers.

Procedure

Enter either Global Configuration mode or VRF Router Configuration mode for a specific VRF context:

enable

configure terminal

Optional: router vrf WORD<1-16>
Create an MSDP peer:

ip msdp peer {A.B.C.D}
Enable an MSDP peer:

ip msdp peer {A.B.C.D} enable

Note

MSDP peer is disabled by default.
Optional: Specify the remote autonomous system (AS) number of the MSDP peer:

ip msdp peer {A.B.C.D} remote–as WORD<0-11>

Example

Switch:1>enable
Switch:1#configure terminal
Switch:1(config)#ip msdp peer 21.0.0.2
Switch:1(config)#ip msdp peer 21.0.0.2 enable
Switch:1(config)#ip msdp peer remote-as 1

Variable definitions

The following table defines parameters for the ip msdp peer command.


Variable	Value
`{A.B.C.D}`	Specifies the MSDP peer IP address.
`WORD<0-11>`	Specifies the AS number of the MSDP peer, 0-65535 (2-Byte AS) 0-4294967295 (4-Byte AS).